Uniform procedures for the measurement of the power frequency electric field and dc electric field when ac/dc power transmission lines are installed in parallel or on shared towers are established in this recommended practice. Based on the mutual influence analysis between parallel ac/dc power transmission lines through the theoretical calculation and on-site measurements, the specification requirements and calibration methods of electric field meters are specified. The measurement ranges and layout of measurement points, data recording and processing, and result evaluation methods of parallel power transmission lines of different voltage levels are standardized. This recommended practice is applicable to electromagnetic environment measurement of ac transmission lines with a voltage not less than 100 kV, dc transmission lines with a voltage not less than ± 400 kV, and parallel transmission lines with a distance not over 100 m.
- Sponsor Committee
- PE/T&D - Transmission and Distribution
Learn More About PE/T&D - Transmission and Distribution - Status
- Active Standard
- PAR Approval
- 2019-06-13
- Board Approval
- 2022-03-24
- History
-
- Published:
- 2022-06-10
Working Group Details
- Society
- IEEE Power and Energy Society
Learn More About IEEE Power and Energy Society - Sponsor Committee
- PE/T&D - Transmission and Distribution
Learn More About PE/T&D - Transmission and Distribution - Working Group
-
WG_paraline_EMM_p2819 - WG for measuring method of electromagnetic environment for the corridor of highvoltage OPTL mixed with AC and DC in parallel
- IEEE Program Manager
- Meng Zhao
Contact Meng Zhao - Working Group Chair
- Degui Yao
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards