Data Center
If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!
Need additional guidance? Check out these Juniper Resources.
Data Center Design Center Documentation Knowledge Base The Feed
Latest Discussion Posts
-
AI-Native Virtual Network Assistant and New High Performing ...
By: Arun Gandhi , 3 months agoHi Everyone, We are excited to share that Juniper is expanding its AI Data Center solutions to quickly deploy high-performing AI training and inference networks that are flexible to design and easier to manage with limited IT resources. ...
-
RE: Forwarding syslog messages to 2 servers
By: spuluka , 20 days agoYes, adding a the second set of identical commands as you note. ------------------------------ Steve Puluka BSEET - Juniper Ambassador IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP - Retired) http://puluka.com/home -------- ...
1 person recommends this. -
RE: Forwarding syslog messages to 2 servers
By: Andres El Gharib , 21 days agoHello! Thanks for answer. Do you mean that I should to re-write these commands but with the new IP? Like this: set services service-set SS_NAT_MOBILE_3_0 syslog host 10.163.90.10 services info set services service-set SS_NAT_MOBILE_3_0 syslog ...
-
RE: Forwarding syslog messages to 2 servers
By: spuluka , 22 days agoAssuming the port is the same you would just add the syslog host commands again with the new ip address. This will create a second stanza for the new server using the same settings as the first one. ------------------------------ Steve Puluka BSEET ...
1 person recommends this. -
Forwarding syslog messages to 2 servers
By: Andres El Gharib , 23 days agoHello there! On the network, It has a CGNAT device where the syslog messages are forwarded to a server collector, but we need to send these messages to another server too. Both servers will be collectors... Here is my script, the active server has ...
-
MX series and ACX's Series Midplane Revision
By: Francisco Jose Rojas Escobar , 24 days agoIs the Midplane REV a requirement when asking parts to providers ? Specially for : - MIC - Chassis - DPC Seems we cannot find any documentation that gives clarifications -- as just last week we were advised that when a REV is higher ...
-
MX series and ACX's Series Midplane Revision
By: Francisco Jose Rojas Escobar , 24 days agois the midplane revision a requirement for high-end configuration ? we have experienced that providers & distributors have a hard time clarifying the reason behind REV & Part number changes specially for the parts : MIC DPC Chassis ...
Announcements
-
Introducing AI-Native Networking
With the right data, the right real-time responses, and the right infrastructure, our industry-first AINative Networking Platform delivers simplicity, productivity, and performance.
Unanswered Posts
Top Contributors in the Community
-
744 Points
-
248 Points
-
168 Points
-
156 Points